Apply a patch

The key elements to pay attention to with the patch application are to make sure you are in the proper directory within the source tree, and the --dry-run and -p options for patch such as -p0, -p1, etc. Basically, the number after the -p option is the number of subdirectory prefixes to strip off the file names in the patch. Hez's current patch has file names a/drivers/cairo.c and b/drivers/cairo.c so you apply -p1 to strip off just the a/ and b/ from the names and patch will find drivers/cairo.c to patch _IF_ you are in the top-level of the source tree. However, if you are in the drivers subdirectory of the source tree, then you have to use -p2 to strip off a/drivers/ and b/drivers from the cairo.c name. Hope that makes sense. The --dry-run option lets you know (a) whether the files to be patched can be found (i.e., whether you are in a directory that is consistent with the -p option you have used), and (b) whether the patch applies cleanly to those files (without actually applying the patch). In any case just remember that --dry-run gives you a chance to experiment with different -p numbers until you discover the correct one for the directory that you are in.

Here is how I discovered that Hez's patch would apply cleanly (without actually patching cairo.c)

software@raven> patch --dry-run -p1 \
< /home/irwin/cairo-xcairo-offscreen-rendering-v2.patch
patching file drivers/cairo.c

The lack of further messages after the "patching file" message indicates the file was found and the patch would apply cleanly. Remove the --dry-run option when you actually are ready to apply the patch. After you apply the patch and evaluate it, you might want to remove it again from your source tree . For that, you use the --reverse option of patch (which reverses the effect of the patch). Of course, again, you would first want to use the --dry-run and --reverse options combined to make sure you are in the right directory with a consistent -p number used before you remove the --dry-run option.